Modelling the E&N in HO Scale in my basement

August 12, 2012

Been a while since I’ve identified a post under “basement development”, but the work Cam and I did this weekend was certainly that work.

Saturday, we made a quick trip to Home Depot, picked up a sheet of 3/4″ MDF and four strips of pre-primed moulding. The sheet of MDF was ripped there to 10 1/2″ and 10 3/4″ wide, per the quick measurements I made earlier in the week.

Sunday morning, I went downstairs and got to work putting a coat of primer on the sides and one of the faces, as well as finishing up the trimming of the drywall to the proper size.

Later that afternoon, Cam came over to assist with getting the shebang installed. After finishing the priming od the bloards, we needed to make a trip to Rona for some ‘tuck tape’ which I needed (but didn’t realize when we picked up the other stuff), we got to work on cutting and installing the casing.

And here’s where I found that the window wasn’t installed very squarely in the opening. A few custom cuts later, we had everything secured, and got the first piece of moulding nailed in. And then pulled it out owing to the fact the brads I was using were too short. Redone with 2″ long brads, all was made secure.

Still to be done is filling of the screw holes, nail holes, siliconing the seams and corners and for this window, applying some small moulding to hide the distance between the casing and the window.

Cheers!

2 Responses

  1. James Powell

    Any more recent updates Jon?

    October 12, 2012 at 9:43 pm

    • Jon Calon

      Unfortunately, no. Haven’t been downstairs much lately, what with taking on a few other commitments. Last work was on the window casing and even then that’s not close to being done.

      October 15, 2012 at 9:45 pm

Leave a Reply to Jon Calon Cancel reply

Your email address will not be published. Required fields are marked *