Modelling the E&N in HO Scale in my basement

Turnouts complete, trackwork not far behind!

It’s extremely gratifying to finally report a completion of a few things, since a lot of progress has taken place with the layout since I’ve written last:

Firstly, I’m done with turnout building and placement!  This weekend I finished spiking down  the switch just outside the Port Alberni enginehouse.  This was the last turnout to be laid.

I still need to hook up a lot of servos, connect them to the Tam Valley Depot Octopus III controllers and figure out how they will be thrown.  Dave Bedard favours toggle switches, I like momentary push buttons.  It would be awesome if I could get Signalogic Systems SCP controls to work; I have them running the few tortoise-powered turnouts on the layout, and to have just one interface would be great.  It’s bad enough to have bullfrog knobs and another means, to introduce a third might make things confusing for the operators.

On other “almost completed” items, I’m less than five pieces of track being spiked down from the milestone of being done laying all trackage.  Two bits of track into the enginehouse (will it be a structure or just the foundation?  I’m trying to determine -without a lot of success- whether the current enginehouse was built prior to 1988 or not.  If you have any info on this, please drop me a line!), the Vancouver Island Gas spur needs its trestle constructed and then two lengths of flex track near the Port Alberni depot need to be spiked down.

Wiring has been done for the majority of the yard in Port; the southern quarter of the yard plus the remaining trackage towards the plywood division still needs feeder wires hooked up.  Some bus wires will also need to be strung too.

Will have to update this post with pictures later, along with updates on a few other bits – the GP9 fleet, the freight car fleet and more.  Stay tuned!

One Response

  1. James Powell

    I heard a rumor about a quick trip to Moncton, thanks for your efforts Jon,

    February 17, 2016 at 4:11 pm

Leave a Reply to James Powell Cancel reply

Your email address will not be published. Required fields are marked *